LAKER PAINT COMPANY PTY LTD

www.lakerpaint.com.au

TECHNICAL DATA SHEET

PRODUCT NAME	VanIsh 2000
DESCRIPTION	VanIsh 2000 is a clear water-based acrylic coating designed to provide a sacrificial barrier to graffiti and marking on masonry, concrete, previously painted surfaces and signwriting. VanIsh 2000 has been specifically designed to leave the appearance of the protected surface unaltered, and will not "yellow" on exposure to sunlight. VanIsh 2000 is resistant to many cleaning agents, some paint strippers, and most paints, but is readily removed by mildly alkaline solutions. VanIsh 2000 is effective as a sealer for timber and other porous surfaces, but should not be considered a clear finish for timber exposed to direct weathering.
SURFACE PREPARATION	Surface must be dry, clean and free from dust, loose particles, grease and oil, etc. Cleaning with high-pressure water (e.g. Gerni) is recommended prior to application of VanIsh 2000.
	Concrete, particularly horizontal slabs, off-form or horizontally-cast items must be thoroughly cleaned to remove release oils and acid etched to remove laitance.
APPLICATION	VanIsh 2000 may be applied by brush, roller or airless spray; conventional spray may also be used where penetration is required.
COVERAGE	Approximately 8m² per litre, depending upon the porosity of the surface to be protected. As a guide, sandstone may achieve only 6m² per litre, whereas over existing coatings,10 - 12 m² may be achieved.
DRYING TIME	Touch dry in approximately30 minutes. Recoat in 16 hours. If the temperature is between 8 and 15º C, allow 48 hours before recoat to ensure the surface is totally cured. Do not apply below 8° C or above 85% Relative Humidity.
CLEAN UP	Water.
COLOURS	Clear only
PACKAGING	1 litre, 2 litre, 4 litre, 10 litre and 20 litre sizes.
DANGEROUS GOODS	Not Dangerous.
PACKAGING CODE	None allocated.